OLED Assembly
Info: USB Tester OLED Backpack Purchase: Tindie The USB Tester OLED backpack is an add-on for the USB Tester for displaying and data logging the voltage and current for any USB device. This allows you...
View ArticleUSB Tester OLED Backpack Description
Introducing the new USB Tester OLED Backpack! This is an add-on for the USB Tester which can be found here: https://tindie.com/shops/FriedCircuits/usb-tester/. Instead of having to connect your Digital...
View ArticleUSB Tester Assembly
Info: USB Tester Buy one: Tindie Included with USB Tester: 1x PCB 1x 14 pin header 1x Jumper Parts included with USB Tester 1. Separate the 14 pin header into two 5 pin and two 2 pin as seen below:...
View ArticleUSB Tester and Phone Charging
One of the many uses of the USB Tester is to see how much current your phone uses while charging. Below is a picture of this setup if you would like to try it. Aerial View Connects to your phone via...
View ArticleOLED Backpack: How to Update Firmware
There are a few downloads you will need before you can update the firmware on your USB Tester OLED Backpack. Preparation: Arduino IDE from www.arduino.cc OLED Firmware from...
View ArticleUSB Tester 2.0
Current Version: 2.0 Purchase: Tindie or FriedCircuits.us Assembly: Here USB device connection D-/D+ test points Top connection to OLED Backpack Current test points – Fits Dual banana clips (.75in...
View ArticleUSB Tester OLED Backpack 2.0
Current Version: 2.0 Purchase: Tindie or FriedCircuits.us Assembly: Here <Need Picture labled> Mode\Clear Button Status LED 128×64 OLED that shows graph, status readout, and peaks Connection to...
View ArticleUSB Tester 2.0 Assembly
Info: USB Tester 2.0 Purchase: Tindie or FriedCircuits.us Included Parts: 1x PCB 16pin Male Header 1 2pin Jumper The assembly is similar to the VA Tester, except only one pin to remove. Having the...
View ArticleUSB Tester OLED Backpack 2.0 Assembly
Info: Purchase: Tindie or FriedCircuits.us 1x Backpack PCB SMD Parts assembled 1x 128×64 OLED 2x 5pin Female Header Note: By default the solder jumper on the bottom is connected to allow shared...
View ArticleAcrylic Base
Parts 4x Long Screws 4x Tall Stand Offs 4x Short Stand Offs 1x 50x31mm Acrylic Sheet Acrylic Base Parts Step 1Start by putting the longer screw through each of the corners and then thread the longer...
View Article
More Pages to Explore .....